Disclaimer! Some of the items might have retired and as such are not listed. Use some of the favourites in your stash as replacements. Start by creating an 'ink smooshing' background with Magenta Madness, Flirty Flamingo and Fresh Freesia ink on a quarter piece of Basic White cardstock. Also create one with Pool Party ink. Cut down to smaller pieces roughly measuring 7cm x 3.5cm. Die cut flowers and stems using the Flowers of Home Dies. Cut 5 of the smaller 'wreath like' pieces from the Pool Party background. Cut six of the the small trio of flowers. Die two of the trio of flowers from Vellum cardstock. Heat emboss the 'Happy Easter' and the 'sending warm and happy wishes...' greetings with Gold embossing powder and fussy (see image). For Standard Card: Start with a standard Fresh Freesia card base, measuring 21cm x 14.5cm, scored and folded at 10.5cm. Adhere three of the negative floral backgrounds to the Fresh Freesia card front. Stamp the bunny from the Easter Friends stamp set with Fresh Freesia ink on to Basic White cardstock. Fussy cut with Paper Snips. Cut a small heart from Basic White cardstock. I used a heart from the Bouquet of Love Hybrid Embossing Folder. Use one trio of flowers die cuts to make a little bud and add leaves (use one some of the leaves from one die cut stem). I used Glue Dots to make the bud and used a Gilded Gem for the centre. Make two Vellum buds in a similar way to use as extra embellishment on this card. Adhere the bunny with Dimensionals over the background layers. Fray a string of the Gold Simply Elegant Trim and pull out one strand to create a cluster behind the bud. Use Stampin' Seal, Glue Dots and Dimensionals to adhere all the pieces (sea image). For the 3" x 3" (7.6cm x 7.6cm) card: Cut a piece of Pool Party cardstock to measure 3" x 6", (15.2cm x 7.6cm) score and fold at 3" (7.6cm). Gold heat emboss the bunny on to Basic White cardstock and fussy cut. Tear two of the Pool Party negative pieces on the right hand side (after checking the correct orientation to create a 'wreath' by putting the two pieces together (see image). Place two of the die cut leave pieces back into the negatives and add two to the sides to complete the wreath. I applied Multipurpose Liquid Glue only on the stem part of the leaves. Layer up the flowers to create buds as well as one with leaves to create a headpiece for the bunny. Adhere all the pieces as shown in the image. Use a little Multipurpose Liquid Glue to adhere the greetings (I used 'warm wishes' for the Standard card and 'Happy Easter' for the small card.